Accelera 225/45 R18 95Y PHI 2024

Accelera 225/45 R18 95Y PHI 2024

The Accelera 225/45 R18 95Y PHI 2024 is a low-profile road tyre for compatible sporty hatchbacks, medium saloons, coupés and selected estate cars. Its 225 mm section provides a broader footprint than narrower compact-car sizes, while the 45-profile sidewall delivers relatively direct steering without being as unforgiving as a 35- or 40-profile tyre.

Main Specifications

The 95 load index represents a maximum rated capacity of 690 kg per tyre when it is correctly fitted and inflated. Its Y speed rating corresponds to a maximum rated speed of 300 km/h under specified conditions. These technical ratings must satisfy the requirements shown in the vehicle handbook or on its tyre-information label.

Everyday Performance

On a car designed for this fitment, the PHI should provide a stable feel during motorway cruising and progressive lane changes. The 225 mm width offers a substantial contact area without producing the heavier steering associated with much wider performance tyres. Its 45-profile sidewall also limits excessive movement when the driver changes direction.

The ride is firmer than it would be with a 55- or 60-profile tyre. Broken asphalt, expansion joints and sharp pothole edges will be felt more clearly inside the cabin. The reduced sidewall depth also gives the 18-inch wheel less impact protection, so drivers should take additional care around kerbs and damaged road surfaces.

Product Information

• Practical 225 mm width for approved passenger vehicles
• Low 45-profile sidewall with responsive steering behaviour
• Maximum rated capacity of 690 kg per tyre
• Y speed rating for cars requiring this specification
• Intended mainly for paved urban and motorway roads
• Manufactured to the stated 2024 specification

Vehicle Compatibility

The 225/45 R18 size is used by various passenger cars, but fitment depends on the exact model, trim and wheel package. A vehicle may require this physical size with a different load index, construction or manufacturer-specific marking. Matching only the wheel diameter is therefore insufficient.

Compare the full markings on the current tyre with the vehicle placard. Similar sizes such as 215/45 R18 and 225/40 R18 are not automatically interchangeable because they have different overall diameters. An unapproved change can affect speedometer readings, wheel clearance and electronic stability systems.

If the car uses staggered wheels, verify whether this size belongs on the front, rear or both axles. Replacement tyres should match across the same axle.

Shop Information

This exact Accelera PHI specification can be ordered through dwbtyres.ae after confirming the vehicle fitment, axle arrangement and quantity required.

UAE Buying Checks

Drivers looking to buy tyres in UAE should inspect low-profile sidewalls after significant pothole or kerb impacts, even when there is no immediate loss of pressure.

Before you buy car tyres in UAE, check the old tyres for inner-edge or shoulder wear. Alignment and suspension problems should be corrected before installation to prevent premature wear on the replacements.